|
05 636 build
|
08-10-2013, 02:49 AM
So I've been on here for a couple months getting info for things I should do to my 636 so far I've found a bunch of good info still trying to figure out things for a handbrake setup this is my first stunt bike I races motocross my whole life and I'm getting into stunt riding I hope I pick it up as well as motocross anyways here is my bike so far any advice on building up my bike would be appreciated
10-17-2013, 03:06 PM
my cage sick cage bent after one crash lol and it wasn't that bad of a crash
10-17-2013, 06:28 PM
All of my atown cages and parts have held up nice and always bolted on/off easily, if your sick cage is toast I would consider atown to replace it. (Link below)
As for the swingarm the 07-08 zx6r bolts up with out having to cut or grind anything but I believe you need to use the 07-08 pivot block and links when you switch also. I would stay with the 05-06 swingarm they don't look that ugly and you know your shock/linkage/chain and everything else will work with it just fine.
10-21-2013, 04:01 PM
Ya sick cages suck I wrecked once and it was not bad at all I had to cut it off my bike all the hard wear was bent and whole throttle side of my cage was bent up so bad I couldn't get to the bolt so I ended up cutting it off my bike I also got a sick round bar and it was a biotch to put on I think this time around I'm goin with Atowns cage
11-18-2013, 02:44 AM
My cage after one small wreck hard wear is also bent to hell had to cut the cage to even get it off
11-18-2013, 02:47 AM
Finally dented my tank today first one I have ever done
11-24-2013, 08:48 AM
MY BET IS you didnt tighten the cage properly down the bottem because SI cages are a top quality cage and it takes a huge huge huge crash to cause that.
|
|
« Next Oldest | Next Newest »
|
Originally Posted by burnoutnut