clutch slipping AGAIN?

[~03~raven]

Originally Posted by Cuong-nutz

Other possibilities:

1. Springs are not torqued as your noted.
2. You're missing a friction disk or steel disk.
3. You're using the wrong type of motorcycle oil.

I doubt it has anything to do with the oil. I'd be more inclined to thinking either 1. or 2. if it isn't something as simple as just the cable needing to be adjusted either on the top or the bottom. 3rd option for me would be it's something to do with the stack height if all the discs are there. I have seen it a couple of times that the brand new EBC discs sometimes have a low stack height even compared to a used worn clutch and the pressure plate can bottom out on the basket causing it to slip. In that case we got some slightly thicker steel plates from EBC, 2 of them to be exact, and swapped those out with two of the steels already in use. Damn tight tolerances.
Oh yea man and if you have an RSC or MSR ez-pull, or something else similar, make sure that little adjuster didn't vibrate into the clutch housing and pressing the lever. Seen that happen a couple of times. Just the small little all-thread piece with the nut on it. Here, not sure who's bike this is, but this is the adjuster thing I was talking about. I got in the habit or removing those.