'05 CBR600RR Changeup Built

[Joe Slow]

Originally Posted by da Liks

Hey buddy! my2 cents: make the bike breathe like stock, no taping off holes or anything. get used to riding a bike with more power/torque. its not much, just a bit! it will benefit you! take off the damn 12 bar and scrape exhaust if necessary. less rigid, more forgiving.
add a second fan, r6 grey fan offcourse. the lower the temp stays the better the idle and response, especially on the RR. clipons baby!!! asap. and an rsc..

Yo dude thanx for the info! I still slam the 12 bar a bit sometimes. Might remove it later though. I removed the blockage on th eairbox this past weekend and my idle was waaay beter and spin/drift also alot easier so thats a check. bike already has 2 fans on with header wrap. just need to get the best coolant I can get now. I've been looking for clipons since I got the bike so those are on the to do list. I fcking hate these high ass DB's. Must say the clutch lever I modded and shortened is really soft. clutch finger never fatigues but my HB middle finger does lol cause its still new to the whole HB maneuver .

Originally Posted by Backwoods

Im having a hard time finding the idle mods and jumper mod for tip over sensor can you help me out on these?

hey man. For idling I just took the stock cable out. Grinded the point shorter and then screwed it into one of the throttle stop screw holes. You just need to remove the one on the right when standing over the bike. Remove the throttle bodies too. A bitch to get it in without removing throttles. Its a 20 min job all in all. Da Liks might need to chip in for tip over sensor cause I got mine with that mod done.

Originally Posted by da Liks

change the fluid first, fresh 10 w.. compression pretty soft, rebound pretty hard. preload is ride height..

Currently running 15w. so you would recommend 10w? Will do it when I get some time. But first I'll just do the suggested settings. I really aint in the mood to do oil this week lol. Thanks a million for the advice man!Appreciated