Stuntride › General Category › General Discussion v
TIG Welding Thread

Linear Mode
TIG Welding Thread
zeus_r6 Offline
Member
***
Posts: 159
Threads: 15
Joined: Nov 2006
Reputation: 0
#19
09-05-2012, 02:51 AM
I'm starting to see that, but anybody that welds knows Miller is pretty much top dog

The 100% argon should work fine for tubing as long as I'm not blowing it away and add plenty of filler rod, right? Going to fishmouth a bunch of smaller sections just for practice on different joints. Fishmouthing bent tubing is a pain! Good advice so far guys keep it coming
Find
Reply


Messages In This Thread
TIG Welding Thread - by zeus_r6 - 09-01-2012, 08:58 PM
TIG Welding Thread - by Duane S. - 09-02-2012, 04:02 PM
TIG Welding Thread - by Graveyard - 09-04-2012, 09:18 AM
TIG Welding Thread - by big ben - 09-04-2012, 09:47 AM
TIG Welding Thread - by tin-man - 09-04-2012, 05:28 PM
TIG Welding Thread - by lucky13 - 09-04-2012, 05:41 PM
TIG Welding Thread - by lucky13 - 09-04-2012, 07:55 PM
TIG Welding Thread - by COTE - 09-04-2012, 08:14 PM
TIG Welding Thread - by Graveyard - 09-04-2012, 10:45 PM
TIG Welding Thread - by lucky13 - 09-04-2012, 11:00 PM
TIG Welding Thread - by zeus_r6 - 09-05-2012, 01:19 AM
TIG Welding Thread - by lucky13 - 09-05-2012, 02:12 AM
TIG Welding Thread - by zeus_r6 - 09-05-2012, 02:23 AM
TIG Welding Thread - by Graveyard - 09-05-2012, 02:37 AM
TIG Welding Thread - by lucky13 - 09-05-2012, 02:39 AM
TIG Welding Thread - by lucky13 - 09-05-2012, 02:40 AM
TIG Welding Thread - by lucky13 - 09-05-2012, 02:44 AM
TIG Welding Thread - by Graveyard - 09-05-2012, 02:44 AM
TIG Welding Thread - by zeus_r6 - 09-05-2012, 02:51 AM
TIG Welding Thread - by 50slut - 09-09-2012, 12:22 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)