Less than 1 minute ago
\r\n \r\n Went to garage yesterday - no pics... But this is the trend of today: project thread without pics, right? 
\n
\nYesterdays progress:
\n
\n- made a rear mount for passenger\'s seat
\n- bent chrash cage lower tube, which goes under the motor
\n- started to fabricate cage\'s front mounts
\n
\nTubes I\'m using in crash cage are two kind of waterpipes. Thinner pipe\'s diameter is 21mm and wall thickness 3mm, thicker pipe\'s diameter is 30mm and wall thickness 2,5mm.
\n
\nI\'m using this thicker pipe in cage front mounts, which also connects all other pipes. All other pipes will be that thinner one.
\n
\nI\'m gonna make another visit to garage in this week, I promise some new pics after that\r\n
\n
\nYesterdays progress:
\n
\n- made a rear mount for passenger\'s seat
\n- bent chrash cage lower tube, which goes under the motor
\n- started to fabricate cage\'s front mounts
\n
\nTubes I\'m using in crash cage are two kind of waterpipes. Thinner pipe\'s diameter is 21mm and wall thickness 3mm, thicker pipe\'s diameter is 30mm and wall thickness 2,5mm.
\n
\nI\'m using this thicker pipe in cage front mounts, which also connects all other pipes. All other pipes will be that thinner one.
\n
\nI\'m gonna make another visit to garage in this week, I promise some new pics after that
\r\n