Less than 1 minute ago
\r\n \r\n Thanks for the positive feedback! I started to build the subframe yesterday. I also made a shark fin and few other minor things.
\n
\nHere\'s some pics:
\n
\n
\n
\n
\nAnd that\'s where I started yesterday.
\n
\n
\n
\n
\nExhaust can comes way too long from the side, I need to shorten that can littlebit and move it forward to get the proper angle and output.
\n
\n
\n
\n
\nChain cut off (I got longer chain already) and rear wheel installed to see the correct ride height. I think I got enough subframe material (and that\'s not all material I got in this pic)
\n
\n
\n
\nSubframe\'s top needs to be narrowed to fit the front seat and the rear fairing\'s front section properly. Seat sits quite nice at the moment.
\n
\n
\n
\n
\nHere\'s the subframe without front seat. Subframe\'s rear section will be as wide as the lower tubes are at the moment.\r\n
\n
\nHere\'s some pics:
\n
\n
\n
\n
\nAnd that\'s where I started yesterday.
\n
\n
\n
\n
\nExhaust can comes way too long from the side, I need to shorten that can littlebit and move it forward to get the proper angle and output.
\n
\n
\n
\n
\nChain cut off (I got longer chain already) and rear wheel installed to see the correct ride height. I think I got enough subframe material (and that\'s not all material I got in this pic)
\n
\n
\n
\nSubframe\'s top needs to be narrowed to fit the front seat and the rear fairing\'s front section properly. Seat sits quite nice at the moment.
\n
\n
\n
\n
\nHere\'s the subframe without front seat. Subframe\'s rear section will be as wide as the lower tubes are at the moment.\r\n