Less than 1 minute ago
\r\n \r\n I\'m still missing the frame\'s inspection document for re-registration (the frame was measured and straight, but the document is missing). Bike is technically ready for re-registration (note those 900rr\'s mirrors and rear left turn signal 
):
\n
\n
\n
\n
\n
\n
\n
\n
\n
\n
\nWhat I\'ve done so far:
\n
\n- all plastics welded
\n- tank repaired
\n- undertray + plate holder fixed
\n- kleen air mod
\n- tip sensor eliminator -mod
\n- lights/mirrors/signals fixed
\n
\n
\nThings I\'m about to do after registration:
\n
\n- DIY-crash cage
\n- DIY-subcage
\n- 1st gen R6 tail
\n- slip-on
\n- MSR stunt clutch
\n- clutch arm mod
\n- roundbar/tail saver
\n- 3D adjustable clipons
\n- Derbi Senda\'s MX mask
\n- 55t sprocket
\n- hole in the seat
\n- shark fin
\n- Renthal grips
\n
\n- 1st gen R6 front fender?
\n- DIY bellypan?
\n- braided lines to front?
\n
\nMore to come...\r\n
):\n
\n
\n
\n
\n
\n
\n
\n
\n
\n
\nWhat I\'ve done so far:
\n
\n- all plastics welded
\n- tank repaired
\n- undertray + plate holder fixed
\n- kleen air mod
\n- tip sensor eliminator -mod
\n- lights/mirrors/signals fixed
\n
\n
\nThings I\'m about to do after registration:
\n
\n- DIY-crash cage
\n- DIY-subcage
\n- 1st gen R6 tail
\n- slip-on
\n- MSR stunt clutch
\n- clutch arm mod
\n- roundbar/tail saver
\n- 3D adjustable clipons
\n- Derbi Senda\'s MX mask
\n- 55t sprocket
\n- hole in the seat
\n- shark fin
\n- Renthal grips
\n
\n- 1st gen R6 front fender?
\n- DIY bellypan?
\n- braided lines to front?
\n
\nMore to come...\r\n