11-09-2011, 06:59 PM
hey Matt Ive dont this, ive got a 05 r6 with a 05-06 636 front end.
it was pretty straight forward but I did not use the 636 triples, i tried but the 05/06 636 triple was too fat to go through the top r6 bearing, and the 05/06 bearing top bearing was to big for the R6 race, so maybe it could be done with a custom top bearing? Im not sure.
I used the 05 R6 triples that were already on there.
this is my set up, its the entire 05/06 front end without the triple
(05 r6 triples; 05-06 636 forks, fender, calipers, wheel, axle, wheel spacers)
the 05 r6 forks where the same length as the 05/06 forks, the fork spacing, left to right between forks, in the triple of the 05 r6 triples and the 05/06 triples are exactly the same,
in this pic you can see the 05/06 forks slid through the 05 r6 triples and the 05/06 bottom triple as well, to see the spacing is the same
it was pretty straight forward but I did not use the 636 triples, i tried but the 05/06 636 triple was too fat to go through the top r6 bearing, and the 05/06 bearing top bearing was to big for the R6 race, so maybe it could be done with a custom top bearing? Im not sure.
I used the 05 R6 triples that were already on there.
this is my set up, its the entire 05/06 front end without the triple
(05 r6 triples; 05-06 636 forks, fender, calipers, wheel, axle, wheel spacers)
the 05 r6 forks where the same length as the 05/06 forks, the fork spacing, left to right between forks, in the triple of the 05 r6 triples and the 05/06 triples are exactly the same,
in this pic you can see the 05/06 forks slid through the 05 r6 triples and the 05/06 bottom triple as well, to see the spacing is the same