09-24-2011, 02:48 AM
ok ill put up sum pics as soon as i can,IT WORKS GREAt!but it was very expensive...well worth it in my opinion..heres what i did. first i orderd this...
http://www.pccmotor.com/rear-brake-a...-crf55050.html
the master cylinder here actually accepts the honda style junction valve from gp tech. i tested it to be sure.perfect fit.if you wanna go that route.i chose not to.
then i orderd this
http://www.pccmotor.com/atv-brake-as...009.html..this this set came with a huge caliper.enough for a 4 wheeler ..which for a handbrake is great!....but the master on this set suckd.and couldnt be combined with a ez pull clutch. so i replaced it with a factory front handbrake master cylinder from a yzf 600.it has a seperate fluid resivoir which can work upside down..
again sorry no pics.my pc is ancient. next i purchased a disc rear rim...
next i installd the foot brake system the way it would be from the factory.using the block on the inside brakeside of the swingarm. i then cut a bracket out of aluminum and mounted the atv caliper right behind the foot brake caliper. drilled sum holes in the caliper brackets and connected the 2 with some short bolts and locknuts. on a stock 50 this would require a bracket to hold up the foot master cylinder as well.mine was on a pit bike which had the mounts already. costly but nasty setup
rim/rotor-65
pit bikee foot brake system-45
atv rear brake system-45
1/4 " peice of aluminum/nuts/bolts/brake fluid-10
a whole bunch of shipping -50
http://www.pccmotor.com/rear-brake-a...-crf55050.html
the master cylinder here actually accepts the honda style junction valve from gp tech. i tested it to be sure.perfect fit.if you wanna go that route.i chose not to.
then i orderd this
http://www.pccmotor.com/atv-brake-as...009.html..this this set came with a huge caliper.enough for a 4 wheeler ..which for a handbrake is great!....but the master on this set suckd.and couldnt be combined with a ez pull clutch. so i replaced it with a factory front handbrake master cylinder from a yzf 600.it has a seperate fluid resivoir which can work upside down..
again sorry no pics.my pc is ancient. next i purchased a disc rear rim...
next i installd the foot brake system the way it would be from the factory.using the block on the inside brakeside of the swingarm. i then cut a bracket out of aluminum and mounted the atv caliper right behind the foot brake caliper. drilled sum holes in the caliper brackets and connected the 2 with some short bolts and locknuts. on a stock 50 this would require a bracket to hold up the foot master cylinder as well.mine was on a pit bike which had the mounts already. costly but nasty setup
rim/rotor-65
pit bikee foot brake system-45
atv rear brake system-45
1/4 " peice of aluminum/nuts/bolts/brake fluid-10
a whole bunch of shipping -50