|
nitro rc help needed
|
06-02-2011, 02:41 PM
you've gotta get the factory start settings on that motor. most of the time the high speed and low speed needles are flush with the outer housing they're in. it could be your idle screw isnt set keeping it from staying running. honestly if you dont have time to learn how to tune then that thing is gonna be as good as a paperweight lol cause tuning is gonna be an everyday thing.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
nitro rc help needed - by maverickxp - 06-01-2011, 10:49 PM
nitro rc help needed - by Nappy - 06-01-2011, 10:55 PM
nitro rc help needed - by ryan711 - 06-01-2011, 11:42 PM
nitro rc help needed - by ryan711 - 06-01-2011, 11:42 PM
nitro rc help needed - by maverickxp - 06-02-2011, 02:01 AM
nitro rc help needed - by maverickxp - 06-02-2011, 02:02 AM
nitro rc help needed - by ryan711 - 06-02-2011, 02:05 AM
nitro rc help needed - by CHILI - 06-02-2011, 02:24 AM
nitro rc help needed - by YSRRider - 06-02-2011, 03:23 AM
nitro rc help needed - by YSRRider - 06-02-2011, 03:30 AM
nitro rc help needed - by maverickxp - 06-02-2011, 04:09 AM
nitro rc help needed - by YSRRider - 06-02-2011, 04:36 AM
nitro rc help needed - by YSRRider - 06-02-2011, 04:37 AM
nitro rc help needed - by ReCkLeSsRyAn - 06-02-2011, 04:44 AM
nitro rc help needed - by ryan711 - 06-02-2011, 04:50 AM
nitro rc help needed - by ryan711 - 06-02-2011, 04:50 AM
nitro rc help needed - by maverickxp - 06-02-2011, 12:24 PM
nitro rc help needed - by J-Stunt - 06-02-2011, 01:08 PM
nitro rc help needed - by maverickxp - 06-02-2011, 02:31 PM
nitro rc help needed - by ATL Darrick - 06-02-2011, 02:41 PM
|
