Impaktech stunt cage installation help

[nuttynu]

Sup everyone, just need some pointers and help and makin sure I'm install it all right.

Doing it 0n my 05 Cbr .

So this Is what came in.

So my questions are, the long threaded rod goes in the engine bolts by the rear set ?

And do I remove the castle nut on the right side of the bike by the rear set?

& for the mounts where usually the "frame slider goes" the black bolts just screws in and the silver one goes on the other correct..?
And what about the provided washer ? Do i need to use em too? So fAr I have it pre set up and almost looks correct but doesn't fully feel secure ..?

On the right side , I installed it with the castle but still on. Is this correct ?

Any help of advice would help, thanks guys.

[nuttynu]

And for this screw "18" , I'm assuming I use the provided bolt and then use the lock nut once it goes thru the engine frame .?


some more pics for verification , took off the engine bolt on the left side, then push out the rod out the right side, now does th castle nut stays, or comes off too?









& what about the spacing for this??

does the provide bolt just goes straight thru with the oem engine spacer and bolts up?


pre set up of what it'll look like

[nuttynu]

bump,

reserved for more phots to come....