Longer Clutch Cable for F4I??

[Diesel_Stunts]

I need a new clutch cable for the rig, the stock is too short, but ive heard you can use a 636 cable?? Anyone doin that or hear of that? What year 636's?

[SKETCHY]

I think a 03/04 cable would work on a chopper its so long

[Ethiopian]

would not work on my f4i, i had the adjuster by the clutch fully adjusted in and the slack on the end was still to much to work in the clutch perch. that was with a 04 636 cable

[Diesel_Stunts]

Hmmm..Thanks for the advice guys! Maybe ill just grab another stock cable, and route it differently???

[SKETCHY]

you could try a CB600F cable. I wanna say its a little longer cause that bike runs beach bars stock.

[Ethiopian]

u trying dirtbars or somthing?

[Diesel_Stunts]

No, just flipped 636 clips. I moved my grips all the way out, slid the clutch down and then i couldn't go full lock to the left, it would pull my clutch. So i routed it in-between my forks, it worked but after a couple wrecks it smashed the cable

[NBstunter]

just go to your local dealer and ask for a longer cable with the same amount stickout out on each end. any helpful parts desk worker will hook ya up no problem

[Ethiopian]

stock should work perfect, i run 12in bars in my clipons with stock cable on the outside of the fork with no biding issues. u sure its not catching on the rad cap when u turn your bars to the left?

[Ethiopian]

nevermind i routed my cable thru the forks, just looked hahaha.