my 636 wont start ...

[WEnis]

ok i blew my motor on my 636 and bought a motor and a frame.. and i pretty much switched everything over to the good motor and frame... but i used the same wiring harness that came with the motor... and i just got everything hooked up and the bike will prime but when i hit the start button theres nothing any ideas?... anything will help... thanks

[StrictlyStunt]

put gas in it!
























does it crank?

Check kick stand sensor & tip sensor

[WEnis]

lol theres gas... and no... no crank at all

[mb32]

sensors!

most likely the kick stand sensor.

[StuntBikeJake]

clutch switch, kick stand switch, tip over switch

[WEnis]

i took out my tip over sensor... checked the kickstand wires and everythings good.. wheres the clutch switch at?

[WEnis]

Originally Posted by suicidl

the 2 wires that went into the stock clutch

do they come off the front of the harness? if so i didnt see anything that looked like it would plug in to the clutch switch

[WEnis]

How do I do that lol

[Ethiopian]

Originally Posted by WEnis

How do I do that lol

paper clip or connect the wires together.

[WEnis]

I'm confused lol