wtb 03/04 636 cylinder heads

[Greg M]

Ok here is the verdict. Kevin is right the k-2 head fits fine. The problem was the head I was trying to fit was warped to shit!

Kevin hooked it up and got me the head quick. Today was a rainy day so I rigged up the motor out of the bike just to hear it run. Runs minty

Bump for starboy Kevin being an excellent seller!

[Aaron Colton]

Quote:

Originally Posted by Greg M It depends. I am looking at one for 50 bucks+ shipping. on ebay now, But it does not have cam cap plate. I have been told its very important to use the original cams and cap plate that came with the head. They are machined differently and can't be interchanged. Maybe the info I was told is wrong. I know the service manual mentions something about it. http://cgi.ebay.com/ebaymotors/Kawas...Q5fAccessories I just found a complete one for 120 shipped. Will prolly grab this one if its the right one. But I need to So if you got one that you don't need I will grab it. If you never took off a head before I could send you directions. You must loosen cam cap bolts in correct sequence to avoid cracking the weak cast plate. http://cgi.ebay.com/ebaymotors/03-Ka...Q5fAccessories

I think I have a few of these. PM me if interested...

[Greg M]

word