Rolling Stoppie???
#1
I saw a guy do the sickest Highchair stoppie yesterday when i was riding. I got the Stoppie down just wondering if you guys had any advice on ho to do a rolling stoppie? Thanks in advance.

-Anthony
Reply
#2
oh bud they are really fun
Reply
#3
I'm the worlds worst at stoppies. Sorry
Reply
#4
everytime i try them i seem to wanna fly off the front of the bike and get run over?
Reply
#5
lots of practice,not really any tips,just grab the shit outta brake, then keep it up using the littlest amout of brake possible
Reply
#6

Quote Originally Posted by *Tanus*
View Post
lots of practice,not really any tips,just grab the shit outta brake, then keep it up using the littlest amout of brake possible

deja vu
Reply
#7
haha, I didnt wanna be a dick and answer one guy and ignore the other,haha
Reply
#8
Technically you have Endo's on lock. If you start to roll endo's then you're doing a stoppie or a front manual in BMX terms. Now that I am done being an asshole... You need to practice, practice, practice....

Start with a little more speed than usual and just keep upping your front brake pressure till the rear wheel starts to come up. Just practice getting it to come up a little and roll it out. You DON'T want to lock and pop at the end.... this is how you're gonna end up flipping them....
Good luck and take it in small steps.
Reply
#9

Quote Originally Posted by MVSBrendon
View Post
Technically you have Endo's on lock. If you start to roll endo's then you're doing a stoppie or a front manual in BMX terms. Now that I am done being an asshole... You need to practice, practice, practice....

Start with a little more speed than usual and just keep upping your front brake pressure till the rear wheel starts to come up. Just practice getting it to come up a little and roll it out. You DON'T want to lock and pop at the end.... this is how you're gonna end up flipping them....
Good luck and take it in small steps.

++1
Reply
#10

Quote Originally Posted by SIC G
View Post
++1

Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)