04 636 build

[loogie]

Quote:

Originally Posted by Paul i heard the stem overall was too short so the 03/04 stem needed to be pressed in

03/04 lower/upper triple milled out to 51mm is the easiest way.

[SQUINTS]

Quote:

Originally Posted by loogie 03/04 lower/upper triple milled out to 51mm is the easiest way.

good to know thanks buddy

[Paul]

Quote:

Originally Posted by loogie 03/04 lower/upper triple milled out to 51mm is the easiest way.

ughhhhh really didnt want to get anything milled. id rather to a stem swap. but thats life

[C-Bear]

No stem isn't too short I use the stock triples off the 09

[Paul]

Quote:

Originally Posted by tsituner08 No stem isn't too short I use the stock triples off the 09

fucking a!!!!!!

[SQUINTS]

Quote:

Originally Posted by tsituner08 No stem isn't too short I use the stock triples off the 09

[C-Bear]

And r6 calipers

[StuntBikeJake]

I wanna run the zx14 rotors with the r6 mono block calipers... so sexy.. and pads are so much cheaper

[C-Bear]

finished my bike tonight besides ff because i dont have a upper stay yet. but i got to ride my buddies r6 today


hahah got this master from 1995 on it for now. hopefully getting a 13mm tomorrow of a local kid

[C-Bear]

and still waiting on my new exhaust, ht moto seats, hohey rearsets, and roundbar so i can put my mint blue tail on..... anyone got an 09 fender haha look how high that fender sits off the tire. Also i gotta get that tank painted and bondoed