Quick nose coaster question

[Righteous 1]

Originally Posted by da Liks

simply bleeding it by hand will also make a whole world of difference, just take the screws out, dunk it upside down in 10w fork oil, push the rod back and forth till no air comes out. then put the screws back in (in the oil) and then take it out and clean it!

Thanks Alex! Mine's completely dissassembled, and the O ring looks shady. I'm just comparing prices of parts vs. a rebuild. Want it to be dialed!

Originally Posted by anarchist35

Labor, Seals, O-Rings and Shear Pin for $65.00...i needed to order a shear pin, and get a tower also, so said eff it and went ahead and spent the extra $40

Thanks bro!

I need a tower, too......

[richd3000]

120-60 on 636, 120-70 on f4i. That's what they call for stock...

[!!A2K!!]

Originally Posted by bojangles

Are the 120/60's the preference of front tire over 120/70's for stoppies?

Always used 120/70s

[ROWDY]

Originally Posted by bojangles

Are the 120/60's the preference of front tire over 120/70's for stoppies?

120/70/17 is what all of the AM Stoppie School rollers use

[Mack-a-Billionaire]

Originally Posted by Righteous 1

Thanks Alex! Mine's completely dissassembled, and the O ring looks shady. I'm just comparing prices of parts vs. a rebuild. Want it to be dialed!



Thanks bro!

I need a tower, too......

Josh holla at me I have a dialed RG3 f4i front that's just sitting

[da Liks]

Originally Posted by ROWDY

120/70/17 is what all of the AM Stoppie School rollers use

and the Dutch chapter..

[ROWDY]

Originally Posted by ROWDY

120/70/17 is what all of the AM Stoppie School rollers use

Originally Posted by da Liks

and the Dutch chapter..

Oh I knew that already

[anarchist35]

Originally Posted by Righteous 1

Thanks Alex! Mine's completely dissassembled, and the O ring looks shady. I'm just comparing prices of parts vs. a rebuild. Want it to be dialed!



Thanks bro!

I need a tower, too......

i have a tower and pin for an f4i PM me if you want it.