Less than 1 minute ago
\r\n \r\n
\nThen stick the head of the bolt into the motor mount adjuster, and you can use a regular wrench on the inside nut instead of putting vice grips on the shaft.
\n
\n
\r\n
\r\n \r\n
\r\n
you take a bolt with a 12mm head, and put 2 nuts on it, then you tighten those 2 nuts against each other as hard as you can. Quote:
\r\n | \r\n \r\n \r\n Originally Posted by ny450\r\n \r\n  \r\n j-stunt what method did you use to get the smaller engine lock adjusters out?...12mm bolt like ryan? just so i dont waste hours trying to figure out an easier way. \r\n \r\n | \r\n
\nThen stick the head of the bolt into the motor mount adjuster, and you can use a regular wrench on the inside nut instead of putting vice grips on the shaft.
\n
\n