Less than 1 minute ago
\r\n \r\n ok so i got my bracket. decided id do a little break down on the install. honestly it pretty easy. so heres the pic of it before i pulled old adjusting block off and put on the new A TEK bracket(which came with some big ass A TEK stickers- REPRESENTIN)
\n
\n
\n slid it on and threw the nut back on. i did have to de-adjust the chain tensioner bolt cause the bracket is longer by a little bit(to give it more leverage and not alow any slop).
\n
\n i am using a right side 03 636 front caliper just because the bleeder is on top but u can use either side. i just loosely installed it for now to get an idea of where i am going to have to do a light trimming so that way i can have 100% pad contact on the rotor once i trim it to where the pads are in full contact.
\n<a href="http://s789.photobucket.com/albums/yy177/mdub4life29/?action=view&current=1291010013377.jpg" target="_blank"><img src="http://i789.photobucket.com/albums/yy177/mdub4life29/th_1291010013377.jpg" border="0" alt="Photobucket" ></a>
\n i will measure to see how tall of a spacer i need and go get one from the hardware store. this is all the further i have gotten tonight im about 4 mintes into the install. been really smooth so far. ill post more pics when i get a little more time to work on it and it isnt as late\r\n
\n
\n
\n slid it on and threw the nut back on. i did have to de-adjust the chain tensioner bolt cause the bracket is longer by a little bit(to give it more leverage and not alow any slop).
\n
\n i am using a right side 03 636 front caliper just because the bleeder is on top but u can use either side. i just loosely installed it for now to get an idea of where i am going to have to do a light trimming so that way i can have 100% pad contact on the rotor once i trim it to where the pads are in full contact.
\n<a href="http://s789.photobucket.com/albums/yy177/mdub4life29/?action=view&current=1291010013377.jpg" target="_blank"><img src="http://i789.photobucket.com/albums/yy177/mdub4life29/th_1291010013377.jpg" border="0" alt="Photobucket" ></a>
\n i will measure to see how tall of a spacer i need and go get one from the hardware store. this is all the further i have gotten tonight im about 4 mintes into the install. been really smooth so far. ill post more pics when i get a little more time to work on it and it isnt as late\r\n