09-09-2010, 07:34 PM
F4i CLUTCH MOD :
Grind out the rivet that holds the swivel/cable connector on the end of the stock arm and drill one more hole about half way down the arm.
Get a piece of flat steel and cut it to size... I did about 5/8 - 3/4 extra length.
Mark and drill out the two matching holes to bolt up to the arm. Then a 3rd hole on the end for the cable connector.
I used 6mm grade 12.9 bolts and made the holes just a tad small so the bolts actually screwed them selves into the arm... the nut on the bottom is just for safe measure.
Grind out the rivet that holds the swivel/cable connector on the end of the stock arm and drill one more hole about half way down the arm.
Get a piece of flat steel and cut it to size... I did about 5/8 - 3/4 extra length.
Mark and drill out the two matching holes to bolt up to the arm. Then a 3rd hole on the end for the cable connector.
I used 6mm grade 12.9 bolts and made the holes just a tad small so the bolts actually screwed them selves into the arm... the nut on the bottom is just for safe measure.