Less than 1 minute ago
\r\n \r\n
\r\n \r\n
\r\n
....\r\n
Quote:
\r\n | \r\n \r\n \r\n Originally Posted by omr\r\n \r\n \r\n ok the bent bracket well you know bend it back but then make your self one of these.... \r\n \r\n \r\n \r\never bend your rear tank mount on your 636.... \r\n \r\ncomming down hard in a spreader or high chair will do it ,or jumping on your tank for one of a hundred reasons.. \r\n \r\nnever again \r\n \r\ni made this out of that stuff they make cutting boards out of ,poly metha etha some thing or other i don\'t know but im sure 3/4 inch ply wood or some thing flat and strong would work... \r\n \r\nit holds the tank up around the whole bottom of the tank so it never bends the rear bracket \r\n \r\ni have had alot of people pm me about this thing i made and can never seem to get any one to understand what the hell im talking about \r\n \r\nso here\'s a pick you could make this out of any thing flat and strong and thick enough to support the rear part of the tank \r\n \r\nthe cut out is for the pump and wires i just zip tied it to the subframe \r\n \r\nthe four holes were already in the peice when i got it they serve no purpose and the black part is just so you don\'t see it under the tank [sharpie lol] \r\n \r\n-omr- | \r\n