$85.00 Secondary (Dual) Caliper Bracket 03/04 636

[A.TEK]

Quote:

Originally Posted by OnEWhEeLNEAL From what Ive read pretty much all radial calipers have the same mounting points so you could pick up almost any radial caliper. I'll let someone else confirm that but I remember reading that in something Bill from FTI posted.

dang, ive started a fabrication trend lol, yes neal, all radials have the same mount points, BUT NOT ALL RADIALS HAVE THE SAME SIZE 'FEET'. well, i call it the 'foot', where you put the bolt through to mount to your forks
FTP, yeahwith slimmer steel u worry about bending under force, i use a cold-rolled aluminum block, it still affords for a much higher tensil strength then hot-rolled. the design here, if you use a gauge to measure spacing then you would no longer need the axle block, it just would keep the nut from moving because there will be a gap from the nut to the lock pin

not to thread jack, but if you take a look at mine, not sure if you can see but the adjustment lines are already marked and scribed, if you have a simple hole in your bracket and use the oem piece over it then ur not getting a precise adjustment but not enough to make a difference