02-18-2010, 04:38 AM
I just changed mine. It's pretty straight forward if you follow the manual. The hardest part was popping the throttle bodies off. Tip- use the the handle of a hammer and wedge it under one end of the throttle body and push down, using the frame as leverage to pry/pop out one side out of the rubber boots. Once one side is out the other side should wiggle free.
Also gonna need a LONG Phillips to loosen the bands on throttle body.
Suppose to use a new gasket on thermostat after removal too, but I used some ATV sealant (I think it's called) and had no problems.
First time I did this, it took all night. This last time i did it in 2hrs.
Good Luck, post up if you have problems.
Also gonna need a LONG Phillips to loosen the bands on throttle body.
Suppose to use a new gasket on thermostat after removal too, but I used some ATV sealant (I think it's called) and had no problems.
First time I did this, it took all night. This last time i did it in 2hrs.
Good Luck, post up if you have problems.