My Righteous Clutch Review

[krazykyle85]

Originally Posted by Righteous 1

98% of us grind on shit to make it work, a lot of times, even on MSRs. Who doesn't spend 1-2 hours cutomizing their setup with ANY lever? If you were to grind out what you needed on the bottom side, it would still look great AND be stronger than your "slimmed down" idea...

If you don't like the current design and don't feel the replacement perch will resolve any of your issues.....then by all means, send it back in mint condition, and I will give you a full refund.

What do I think about it?....well, I love it with the correct perch....and yes, I run it on the inside, also.

It's up to you, Kyle. With the correct perch, its very SIMILIAR to an MSR. A bit bulkier and different, but very similiar, I'm sure you'ld agree. I'll send ya a perch or you can send back the whole shibang....up to you.

damn i have no idea what you do to your shit.. but it takes me less then 5 mins with a new msr to cut off the ball tip and bolt it on and im good...

but like i have said i was under the impression it was similiar to the msr. which what i got it not. its not ablt to be used in the same way...

to me the only way someone who runs there handbrake on the inside like mine would be able to use it is if i moved my handbrake towards my grip... but then id have to cut my hb lever.


and ill say it again.. its a stupid idea to make a product were you have to notch to fit... your hb setup... you need to put down the pipe and rethink this design is my


the lever is to short and clamp is to bulky... those things need to be addressed before i would consider it a msr beater... ill return it and buy 2 msr's if the design is going to stay the same