03-08-2014, 11:32 AM
I'm looking to use this setup for the Gopro I just purchased however I wasn't too sure of the process when binding the bondo mould to the mount and helmet.
Are the image titles I use below correct? My understanding is that you sanded the mount and bondo mould so they could stick together using silicon caulk. Then you reattached the 3M adhesive to the bondo mould and helmet.
Are the image titles I use below correct? My understanding is that you sanded the mount and bondo mould so they could stick together using silicon caulk. Then you reattached the 3M adhesive to the bondo mould and helmet.