2013 ZX6R build

[kirny]

Originally Posted by JohnnyP

I doubt Driven has the opportunity to try their clipons on every bike with 50mm forks

And they are not listed to fit my bike specifically, they only list them as a 50mm clipon....

If you look at an average fork. it starts off thick where the seals are, then goes thinner until where the bottom triple grabs it, then it goes thin again up until where the clipons and triple clamp grab it.....

On my bike there is only about 1" of the 50mm part left under the triple before it goes thinner.....The Driven clipons were about 1.5" thick, leaving about 1/2 not touching the fork at all....The bolt spacing makes the bottom want to collapse since there is nothing behind it.....Also giving it a loose feeling no matter how tight you make them


I just dealt with the same issue on a 2006 GSXR 600 track bike I am building for someone, and Woodcraft actually makes a special set for that bike. That has a lip on the inside at the bottom to make up for the thinner part in the fork....So other bikes have the same issue

OK, I figured that is what you were talking about and this is on the 2013 fork correct?