07-21-2013, 02:33 AM
Now in two delicious flavors! R6 and 636!
The R6 model is a one piece design that requires no modification to either the rotor or hub to use. This is for a 298 mm front rotor off an R6 and mounts to a rear R6 hub. Just use the same rotor bolts to assemble.
backside:
And for the 636 model, I had to go with a two piece design. You will need to grind the free float rivets off of a 03 04 front rotor (280mm) and remove the inner aluminum piece, then clamp it between these two plates with the standard rotor bolts.
$100 for the 636 and $75 for the R6. I'm going to order the metal on Monday, so if you want in on the first batch, post what you want! Also The first two to claim one get $25 off!
The R6 model is a one piece design that requires no modification to either the rotor or hub to use. This is for a 298 mm front rotor off an R6 and mounts to a rear R6 hub. Just use the same rotor bolts to assemble.
backside:
And for the 636 model, I had to go with a two piece design. You will need to grind the free float rivets off of a 03 04 front rotor (280mm) and remove the inner aluminum piece, then clamp it between these two plates with the standard rotor bolts.
$100 for the 636 and $75 for the R6. I'm going to order the metal on Monday, so if you want in on the first batch, post what you want! Also The first two to claim one get $25 off!