04-30-2013, 02:15 AM
Took the entire master apart today after work and found a little bit of schmagma, looked like solidified brake fluid. But other then that its clean as a whistle inside. Took the bleeder and banjo out as well. Looking at it the russel Banjo 90* fitting has a lip on both sides with a small channel in the middle for the fluid to pass through. I used the depth gauge on a set of vernier calipers to see what the amout of lip was until it was to the recess where the fluid goes and its off. I would work if i didnt use crush washers...but that wouldnt do me any good anyways cuz it'd just leak. FUCK...going to the parts store tomorrow and buying the Russel specific banjo bolts for the Russel lines i put on. ill order new washers while im at it.
