03-12-2013, 05:49 AM
More work done today. i wrapped the forks in black duct tape. i don't think it looks half bad. rear sets on. NDC bracket installed. Im having trouble getting it to sit right. I ground down the lower screw on the adapter, which helped a little bit. The thing is the rotor screws are still hitting the back of the bracket.
Should i take the shell off and grind down the heads of the bolts a little? the wheel will spin, but it still hits. any advice?
and yes i did the other one i just forgot to take a pic
Should i take the shell off and grind down the heads of the bolts a little? the wheel will spin, but it still hits. any advice?
and yes i did the other one i just forgot to take a pic