04 636 stunt setup

[JohnnyP]

Originally Posted by tys0n

Installed the Stunter X ignition relocation bracket. Instructions are very vague not that i usually use them anyways but this was surprisingly a lot harder to install than i thought. I also received the wrong size bolts as they were too short so i had to pick some up from the hardware store.



Special thanks to JohnnyP for sending me some bearing assemblies for my swingarm Not to mention throwing in the chain guide for free. All at a great price! Thanks again!!



i picked up a bushing driver set from the Cornwell guy at work last week.. I don't know that it will fully seat the bearings but it should def get them started nice and easy.

That driver set will work really good, just clean the bores really good and lube everything up nice before you start. Try to get them started straight and its easy