09-10-2012, 05:59 PM
The ballie is busy designing a bracket for the foot and handbrake to CNC out.
Will also CNC a shark fin for the rear sprocket to save my precious fingers
I gotta beat my rear rim some more to make it hold air, and if that doesnt work, send it to get straightened.
Need a throttle body sync.
Need to weld up a slight crack in tank so i can put surf pad in it for grip.
I need to change out the oil and will probably do the clutch arm mod at the same time for an easier clutch pull.
Quite a bit before she is gonna be running niiiice
Will also CNC a shark fin for the rear sprocket to save my precious fingers
I gotta beat my rear rim some more to make it hold air, and if that doesnt work, send it to get straightened.
Need a throttle body sync.
Need to weld up a slight crack in tank so i can put surf pad in it for grip.
I need to change out the oil and will probably do the clutch arm mod at the same time for an easier clutch pull.
Quite a bit before she is gonna be running niiiice