08-22-2012, 08:06 PM
The tube was bent 90 degrees with a 3" radius. I didn't measure the angle I cut it at, but you can see in the pictures the cut almost touched the back of the can, so a quick mock up should be all you need.
|
XR50 undertail exhaust mod
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
XR50 undertail exhaust mod - by 762SPR - 08-22-2012, 10:38 AM
XR50 undertail exhaust mod - by 762SPR - 08-22-2012, 10:49 AM
XR50 undertail exhaust mod - by buddy lenzin - 08-22-2012, 10:51 AM
XR50 undertail exhaust mod - by 762SPR - 08-22-2012, 11:01 AM
XR50 undertail exhaust mod - by 762SPR - 08-22-2012, 11:06 AM
XR50 undertail exhaust mod - by buddy lenzin - 08-22-2012, 11:17 AM
XR50 undertail exhaust mod - by Larse - 08-22-2012, 03:00 PM
XR50 undertail exhaust mod - by 762SPR - 08-22-2012, 08:06 PM
|
Users browsing this thread: 1 Guest(s)