08 WR250X Stunt Build
#11
Stubbz, I got a Magura rear hand brake but have no idea how to bleed it properly, does it take a combonation of bleeding the small bleeder on the brake itself and the caliper or just the caliper? I also have no idea how or where to put the master? right now its zip-tied to the clutch cable...bad idea?

I will post a video of the exhaust, I recently got a P1 tip it was really really loud at WOT
Reply


Messages In This Thread
08 WR250X Stunt Build - by Rotorxhead7 - 08-06-2012, 12:03 AM
08 WR250X Stunt Build - by Stubbz63 - 08-06-2012, 02:01 PM
08 WR250X Stunt Build - by Stubbz63 - 08-06-2012, 02:05 PM
08 WR250X Stunt Build - by ajbsays - 08-06-2012, 04:24 PM
08 WR250X Stunt Build - by Rotorxhead7 - 08-06-2012, 08:03 PM
08 WR250X Stunt Build - by Stubbz63 - 08-06-2012, 08:50 PM
08 WR250X Stunt Build - by Stubbz63 - 08-06-2012, 08:52 PM
08 WR250X Stunt Build - by Rotorxhead7 - 08-08-2012, 11:29 PM
08 WR250X Stunt Build - by ajbsays - 08-09-2012, 02:38 AM
08 WR250X Stunt Build - by Stubbz63 - 08-09-2012, 01:25 PM
08 WR250X Stunt Build - by Rotorxhead7 - 08-10-2012, 08:14 PM
08 WR250X Stunt Build - by Stubbz63 - 08-10-2012, 08:28 PM
08 WR250X Stunt Build - by Rotorxhead7 - 08-10-2012, 10:35 PM
08 WR250X Stunt Build - by Stubbz63 - 08-11-2012, 03:04 PM
08 WR250X Stunt Build - by Rotorxhead7 - 08-12-2012, 12:21 AM
08 WR250X Stunt Build - by Stubbz63 - 08-13-2012, 01:34 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)