Less than 1 minute ago
\r\n \r\n Weeeeell. 
Everything was going pretty steady. Had a ton of new bearings to put in, so got all that done. The last ones I went to do, the needle bearings on the swingarm were.....idk, fucked up. They were some how too small, the sleeve wouldnt go in. Wasnt even close to going in, busted one of the needles out of it so now I gotta pull them out. Just spent the last hour trying to get them back out and they are literally stuck.....wont come out. ANYWAY, everything else went pretty smooth, got the engine mounted and all the adjusters set right, so when I get the rest of the stuff from powder tomorrow and these bearings pressed out, im hoping everything will go pretty smooth. Heres how she sits tonight while im off to bed, hope to have it finished tomorrow night:\r\n
Everything was going pretty steady. Had a ton of new bearings to put in, so got all that done. The last ones I went to do, the needle bearings on the swingarm were.....idk, fucked up. They were some how too small, the sleeve wouldnt go in. Wasnt even close to going in, busted one of the needles out of it so now I gotta pull them out. Just spent the last hour trying to get them back out and they are literally stuck.....wont come out. ANYWAY, everything else went pretty smooth, got the engine mounted and all the adjusters set right, so when I get the rest of the stuff from powder tomorrow and these bearings pressed out, im hoping everything will go pretty smooth. Heres how she sits tonight while im off to bed, hope to have it finished tomorrow night:\r\n