How to: DIY Hole in seat

[762SPR]

Originally Posted by montijo_420

Damn I feel lil I got robbed now lol I just pains hella money for my seat from htmoto and the rear didn't even fit once I got it back I asked to have it built up ward 1/4" so if I were to flop down on my ass I wouldn't catch the step plate and the went out forward 1/4" and now I couldn't even put the seat back on with my step plate on it and it has fresh powder on it I had to tweak it out ward on the mount and chipped all the powder but I guess no big deal cause it's hidden but now it take 20 mins just to get the fukn seat off that high dense stuff makes shit difficult but very durable
And by the way Awsome job on the seats looks pimp!!

Thanks! If your seat isn't fitting right, you could try pulling the staples on the bottom and then shaving some of the foam with a sharp knife. Then just stretch and staple it back together. You'll need a pretty powerful stapler though, I would check out one of the electric ones if I was going to do another seat. I have a pretty high quality one manual one from the home improvement store and it just barely goes into the plastic so I have to push the staples in the rest of the way with a hammer head or something. Use 1/4" long staples or whatever length you pull so they don't go too deep and wreck your cover (or ass!)