Less than 1 minute ago
\r\n \r\n radiator issue is a simple fix. grind off the nipple and drill/tap run a bolt through. DONE BOOM.
\r\n
\r\n
\r\nNever had a transmission issue. Don\'t be an asshole and/or start your bike in gear to.
\r\n
\r\nSubframe is pretty straight as long as you keep stock exhaust. most subs i broke with a yosh can. - if you go aftermarket or low mount, better just call Runman get one like Tolers.
\r\n
\r\nTank is sweet. o town dent with a lip.
\r\n
\r\nimpaktech is solid for this bike but rolls up on the bars. Run either a sick or an a town.
\r\n
\r\nJohnny P upper stay is the only way to go.
\r\n
\r\nTail plastic run a few layers of fiber glass under it to keep it solid.
\r\n
\r\nHeader wrap and a switch to run fan all the time.
\r\n
\r\nget an ohlins and a fork clamp. drill a hole in the middle of the ram air tube of frame and boom best damper set up around.
\r\n
\r\nI made a foot plate and drilled it into the little nubs where the back seat goes in or just get a really nice HT moto build up on the cut out part. Always had issues getting my foot in there but i\'m a giant.
\r\n
\r\n
\r\nReally great bikes, but frames are weak like all other kawis.
\r\n
\r\nHad lots of valve problems, and spun bearings, and rod knock. and just all aroun f\'n up motors.
\r\n
\r\nSomewhat miss that bike.. except for the working on it all the time part.\r\n
\r\n
\r\n
\r\nNever had a transmission issue. Don\'t be an asshole and/or start your bike in gear to.
\r\n
\r\nSubframe is pretty straight as long as you keep stock exhaust. most subs i broke with a yosh can. - if you go aftermarket or low mount, better just call Runman get one like Tolers.
\r\n
\r\nTank is sweet. o town dent with a lip.
\r\n
\r\nimpaktech is solid for this bike but rolls up on the bars. Run either a sick or an a town.
\r\n
\r\nJohnny P upper stay is the only way to go.
\r\n
\r\nTail plastic run a few layers of fiber glass under it to keep it solid.
\r\n
\r\nHeader wrap and a switch to run fan all the time.
\r\n
\r\nget an ohlins and a fork clamp. drill a hole in the middle of the ram air tube of frame and boom best damper set up around.
\r\n
\r\nI made a foot plate and drilled it into the little nubs where the back seat goes in or just get a really nice HT moto build up on the cut out part. Always had issues getting my foot in there but i\'m a giant.
\r\n
\r\n
\r\nReally great bikes, but frames are weak like all other kawis.
\r\n
\r\nHad lots of valve problems, and spun bearings, and rod knock. and just all aroun f\'n up motors.
\r\n
\r\nSomewhat miss that bike.. except for the working on it all the time part.\r\n