Fawk you vortex cap

[old man roger]

Originally Posted by old man roger

if you have the type of vortex cap that has the little check ball in it take out the little ball and spring from the base then seal the base to the tank with a rubber gasket ...

the ball and spring always end up sticking allowing pressure to build in the tank and that pushes out almost any gasket but if the ball and spring are gone any pressure will bleed out the over flow ..

Originally Posted by Scott. Chychul

Sooo i basically EPIC FAIL'd.. You pobably should have mentioned that earlier, lol. I think drilling a hole top left shelf will be money.. No need for balls, its high so less change of gass spillage and everything will be ookkk..

i mentioned it [see above] but yeah you can just drill a super tiny hole so the filler hole can vent to the well and any gas that gets in there will spill out the drain hole instead of on your ass ..as long as your base is sealed to the tank that is