05-07-2011, 07:04 PM
Does Bill still make those dual-caliper setups? I too need a new setup badly ha ha 
I had a caliper mounted where the stock rear rotor guard/mudguard was located but cracked the welds last week. Popped right off after hitting it too hard
, still worked for straightline combos and smooth circles up until then though.

I had a caliper mounted where the stock rear rotor guard/mudguard was located but cracked the welds last week. Popped right off after hitting it too hard
, still worked for straightline combos and smooth circles up until then though.


