F4i Clutch Arm Mod ... Must Have

[SEAN_PARRISH10]

Grind out the rivet that holds the swivel/cable connector on the end of the stock arm and drill one more hole about half way down the arm.


Get a piece of flat steel and cut it to size... I did about 5/8 - 3/4 extra length...


Mark and drill out the two matching holes to bolt up to the arm... then a 3rd hole on the end for the cable connector.



I used 6mm grade 12.9 bolts and made the holes just a tad small so the bolts actually screwed them selves into the arm... the nut on the bottom is just for safe measure.

[SEAN_PARRISH10]

Also You Hav To Bend Where The Clutch Cable Mounts On That Bracket .. Inwards Toward The Motor ... So The Cable Pulls Smoother

[thomas]

good one.. i need to do that one day

[SEAN_PARRISH10]

It Only Took About 10 Mins .. A Drill And 4dollars Worth Of Stuff From Lowe's ...

[Nappy]

I haven't done this mod yet. i'll give it a shot.

[*Tanus*]

how long did you go? looks like 1/2 inch?

[Raf]

Quote:

Originally Posted by *Tanus* how long did you go? looks like 1/2 inch?

yup 1/2 inch like your peepee

[JohnR]

so did this make a noticable difference???

[*Tanus*]

Quote:

Originally Posted by Raf yup 1/2 inch like your peepee

1/2 inch, from the ground

[Nappy]

Quote:

Originally Posted by *Tanus* 1/2 inch, from the ground

Why is it 1/2 inch from the ground? You takin it from behind? Or just way oversized? I feel bad for ya either way!