+- Stuntride (https://stuntride.the-nags.com)
+-- Forum: Stunt Discussion (https://stuntride.the-nags.com/forumdisplay.php?fid=4)
+--- Forum: Projects and Builds (https://stuntride.the-nags.com/forumdisplay.php?fid=104)
+--- Thread: 2014 Street Triple Build!!! (/showthread.php?tid=53402)
2014 Street Triple Build!!! - Mr Weber - 08-04-2026
So after talking with other street triple riders, I find out the the lock pin for the seat is a weak point and can pull out of the seat pan pretty easily, so I decided to add a couple anchors so I can bolt the seat pan to the sub frame. I will have to keep a close eye on how well this holds up. If I would have done more research I would have added them before I had my seat done so I did'nt have to open up the strap tabs. Here are a few pics to show what I have done. I may add 2 more closer to the tank for added support
The anchor I used
The anchor installed
Bolted to the subframe (not the correct bolt pictured lol)
2014 Street Triple Build!!! - Mr Weber - 01-23-2015
I have wanted to build a Triumph for a few years now and decided to pull the trigger, I found a sweet deal on a used 2014 and it's going under the knife!! I am already in the middle of this build and will post more pictures soon
2014 Street Triple Build!!! - JBoom - 01-23-2015
Originally Posted by Mr Weber
I have wanted to build a Triumph for a few years now and decided to pull the trigger, I found a sweet deal on a used 2014 and it's going under the knife!! I am already in the middle of this build and will post more pictures soon
2014 Street Triple Build!!! - Mr Weber - 01-23-2015
The first week I started tearing it down and boxing up most of the nice parts, lights, tank ect.. removing wiring, chain, sprockets and began researching and ordering parts!
2014 Street Triple Build!!! - Mr Weber - 01-23-2015
After doing a bunch of searching, there was only one company that made a caliper bracket for the 13-14 models. Jokerider makes a real nice bracket but it's a 300mm big rotor kit, and I had actually already bought one from them for my F4i. I personally did not like it at all. The craftsmanship, fit and finish were really good, but the breaking power was just too much for my liking. So I did some measuring and it just so happened the axle diameter and rotor diameter was the exact same as my F4i! So I borrowed my NDC bracket from my F4i to see if I could make it work!!
2014 Street Triple Build!!! - Mr Weber - 01-23-2015
Instead of completely destroying the F4i bracket, I just machined an adapter bracket that bolts up to it just incase I ever want to use it on a F4i again. The spacing was a little different so I also had to do a little milling and shimming to get it correct!
2014 Street Triple Build!!! - Mr Weber - 01-23-2015
A custom 60 tooth sprocket should work nicely with a 14 tooth front! 520 conversion
2014 Street Triple Build!!! - JBoom - 01-24-2015
Originally Posted by Mr WeberInstead of completely destroying the F4i bracket, I just machined an adapter bracket that bolts up to it just incase I ever want to use it on a F4i again. The spacing was a little different so I also had to do a little milling and shimming to get it correct!
2014 Street Triple Build!!! - Mr Weber - 01-24-2015
Originally Posted by JBoom2014 Street Triple Build!!! - JBoom - 01-24-2015
Originally Posted by Mr Weber